order to arm the system. This light will only illuminate
if all zones are closed. All doors and windows must
be closed, and there can be no movement in areas
monitored by motion detectors. Once the "READY"
light is on, enter your user code. If you make a
mistake entering your code, the keypad sounder
“
END/REJECTION” beep will let you know. Just press
[CLEAR] and re-enter the code.
When you have correctly entered your user code, the
red "
ARMED
" light will come on, and you will hear the
keypad “
CONFIRMATION
” beep. The "
READY
" light will
flash and the keypad will "beep" (if programmed)
during the exit delay period. (Note: The last 10
seconds the beep will be faster.) [
STAY
] and [
AWAY
]
keys will flash
*
. Your installer will program exit delay
duration based on the time you require to safely exit
the protected area once the system is armed.
*
On control panel models 728, 728 EXPRESS and 738
EXPRESS using software version 2.1X, keys indicated
will not flash, but will be constantly illuminated. Software
versions 2.2X onward, keys indicated do not illuminate.
(2) “STAY” arming [STAY] + CODE OR KEY [11]
(partial system arming)
“Stay” arming allows you to remain in the protected area
while “partially” arming the system. This means that you
can stay in and move around your home, or commercial
building, while certain designated zones are armed. You
might choose to have entry/exit points like doors or
windows protected, or the basement, or perhaps all the
zones on the perimeter of your home or establishment.
Based on your instructions, your installer programs
the control panel to arm certain zones in “Stay
arming” mode. These programmed “Stay” zones will
arm on "Stay" mode and can only be changed by
your installer. Please remember that fire zones
cannot be bypassed. (Using this convenient feature,
you can "Stay" arm the system and then leave the
premises while others remain in the protected area.)
Pressing [
STAY] + ACCESS CODE (or KEY [STAY/11] - see
below) on the keypad, activates “Stay arming”
command. “Stay” arming can also be activated by a
key switch - refer to “key switch/push button arming”.
(3) “ONE KEY” arming
(One touch system arming - no code required)
KEY [10] regular arming
When the "
READY
" light is on, pressing key [10] steadily
for 2 seconds automatically "full" arms the system, if
programmed. No user code is required. This feature
can be used to allow specified individuals like service
personnel (i.e. cleaners, maintenance) to arm the
system when leaving the protected area, without giving
them access to any other panel operations.
K
EY [STAY/11] “Stay arming”
Please refer to “Stay” arming section above for a full
explanation of this feature. There is no need to wait
8
9
(64 Seiten)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Kommentare zu diesen Handbüchern