SEKURE DGP2-641 Installationshandbuch PDF herunterladen (Seite 15)

IGIPLEX

NE C

ONTROL

ANEL

Figure 3-6: Single Zone Input Connections

3.14 D

OUBLE

ONE

ONNECTIONS

Enabling the ATZ feature (see section 5.2) allows you to install two

detection devices per input terminal. Connect the devices as shown in

Figure 3-7. Devices connected to input terminals must be assigned to a

zone and the zone's parameters must be defined (see Zone Programming

on page 16). For UL listed installations, use EOL resistor part

#2011002000.

Figure 3-7: Double Zone Connections

3.15 C

ONNECTING

THE

DGP2-ZX4

The 4-Zone Hardwire Expansion Module (DGP2-ZX4) provides four

additional hardwired input terminals (8 zones with ATZ enabled). It

connects directly to the control panel through its on-board

EXPANSION

connector as shown in Figure 3-3: on page 10. Connect detection devices

to the DGP2-ZX4's terminals in the same way that they are connected to

the control panel as shown in Figure 3-6 or Figure 3-7 on page 13. Devices

connected to hardwired input terminals must be assigned to a zone and the

zone's parameters must be defined (Zone Programming on page 16). For

the 4-Zone Hardwire Module (APR3-ZX4), refer to the DigiplexNE Modules

Programming Guide.

Enable ATZ (see section 5.2 on page 17)

and connect as follows (extra input

cannot be used)

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 65 66

Keine Kommentare

SEKURE DGP2-641 Installationshandbuch Seite 15